Chapter 3. Setup
( 33 / 58 )
3.4.2 Connecting to a 48-pin 0.5-mm-pitch Foot Pattern
Here following is a procedure of connecting to a 48-pin 0.5-mm-pitch foot pattern on the user system using the
M30260T-48FPD (included with the M30260T-EPB-GP). For details on the M30260T-48FPD, refer to its user's
manual.
(1) Mount the NQPACK048SD included with the M30260T-48FPD to the user system.
(2) Attach the YQPACK048SD included with the M30260T-48FPD to the NQPACK048SD and secure it with the
YQ-GUIDE's.
(3) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M30290T-EPB.
(4) Attach the M30260T-48FPD to the YQPACK048SD.
Figure 3.11 Connecting to a 48-pin 0.5-mm-pitch foot pattern
CAUTION
Notes on Connecting the User System:
z
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the
emulator and targets system.
z
The connectors of the M30290T-EPB and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
: No. 1 pin
* : These products are included with the M30260T-48FPD package.
48-pin 0.5-mm-pitch
(48P6Q-A) foot pattern
YQ-GUIDE (x4) *
YQPACK048SD *
NQPACK048SD *
HQPACK048SD
(not included)
MCU with on-chip
flash memory etc.
(1)
(2)
(3)
(4)
M3T-FLX160-EPB
M30290T-EPB
M30290T-PTCB
M30260T-48FPD
(1) Debugging
(2) On-board evaluation
Summary of Contents for M30290T-EPB
Page 36: ...M30290T EPB User s Manual 36 58 MEMO...
Page 56: ...M30290T EPB User s Manual 56 58 MEMO...
Page 58: ......
