( 4/4 )
8. External Dimensions of the M30262T-PTC (Connector) and a Sample Foot Pattern
(see Figure 6)
Figure 6 External dimensions of M30262T-PTC and sample foot pattern
9. Precautions
CAUTION
Cautions for Debugging M16C/262 with an Emulator for M16C/62P:
The cautions for software development of M16C/26 using the emulator for M16C/62P (M3062PT-EPB or
M3062PT3-RPD-E) are as follows.
(1) NMI*
M16C/26: NMI* is disabled after reset. Set the P8
5
/NMI* function select bit (bit 4 of address 001E
16
) to "1" to
use the NMI* interrupt.
M16C/62P:NMI* is enabled after reset.
(2) Port P8
5
M16C/26: Port P8
5
has direction and pull-up control registers.
M16C/62P: Port P8
5
functions only as an input port. Thus, debugging of port P8
5
output and pull-up functions
cannot be performed with the M16C/62P tool.
(3) Flash memory suspend mod
M16C/62P flash memory does not support the M16C/26 suspension mode. Thus, debugging of the suspension
function cannot be performed with the M16C/62P tool.
When starting up a debugger (M3T-PD30F or M3T-PD30), select the following MCU file according to the emulator
for M16C/62P.
(1) When you start up the M3T-PD30F using the M3062PT-EPB, select “M16C62P.mcu”.
(2) When you start up the M3T-PD30 using the M3062PT3-RPD-E, select “M3062PT3.mcu”.
IMPORTANT
Notes on This Product:
When connecting the M30262T-PTC, be sure to use the included YQ-GUIDE's
Do not use the screws included with the YQPACK048SD for connecting the YQPACK048SD
We cannot accept any request for repair.
For purchasing the NQPACK048SD, YQPACK048SD and HQPACK048SD, contact the following:
Daimaru Kogyo Ltd.http://www.daimarukogyo.co.jp/
Tokyo Eletech Corporationhttp://www.tetc.co.jp/e_tet.htm
For inquiries about the product or the contents of this manual, contact your local distributor.
Renesas Tools Homepage http://www.renesas.com/en/tools
30.0
32
.0
JP1
IC1
1
M30262T-PTC REV.A
1
50
P1
5
/IN
T3
ADT
R
G
16.5
Unit: mm
10
.0
10.0
6.5
6.5
0.5
0.25
