Renesas Emulation Pod M30830T-EPB, User Manual

Page: 29 / 74

( 27 / 72 )
(2) Changing the Internal Oscillator Circuit of the Emulator
An oscillator circuit board (OSC-3) for 30 MHz is mounted on the PC7501 emulator main unit. To
use the emulation probe at a frequency other than 30 MHz, build the desired oscillator circuit on the
included OSC-2 oscillator circuit board (bare board) and replace the board installed in the PC7501
emulator main unit when shipped from the factory.
Figure 3.4 shows a view of the OSC-2 oscillator circuit board (bare board) and where connector pins
are located. Figure 3.5 shows the circuitry of the OSC-2 oscillator circuit board (bare board). Use the
number of oscillator circuits recommended by the oscillator manufacturer.
Figure 3.4 External view of the oscillator board (OSC-2) and connector pin assignments
J1-4: GND
Figure 3.5 Circuit of the oscillator board (OSC-2)
J1-3: Oscillator output
J1-2: GND
J1-1: Vcc
* X1: 5.08-mm-pitch 2-pin oscillator IC1: Inverter (Unbuffer)
* X2: 2.54-mm-pitch 2-pin oscillator
* X3: 2.54-mm-pitch 3-pin oscillator
IC 1
R 1
C2 C 1
X 1 ,X 2
C LK
V cc
G N D
R 2
J1-3
10 11 8 9
2 1
4 3
6 5
12 13
C 3
IC 1
J1-1
J1-2
J1-4
G N D
IC 1
* *
X 3
*
IC 1
14
7