Renesas Emulation Pod M306N4T3-RPD-E, User Manual

Page: 27 / 76

( 27 / 76 )
Chapter 3. Setting Up
This chapter describes switch settings required for using this product and how to connect this product to the PC4701 and
the target system.
3.1 Removing and Closing the Upper Cover ..................................................................................... 28
3.2 Each Setting ................................................................................................................................. 29
3.3 Selecting Clock Supply and Replacing Oscillator Circuit Boards .............................................. 30
(1) Clock Supply to the MCU .................................................................................................... 30
(2) Using the Oscillator Circuit on the Target System ............................................................... 31
(3) Changing the Internal Oscillator Circuit of the Emulation Pod ............................................ 32
(4) Replacing Oscillator Circuit Boards ..................................................................................... 33
3.4 Switch Settings ............................................................................................................................ 34
(1) Toggle Switches SW1 to SW5 on the M30620T3-PRT Board (MCU-dependent 1) ........... 34
(2) Jumper Switches JP1 and JP2 on the M30620T3-PRT Board (MCU-dependent 1) ............ 36
3.5 Installing and Removing Pullup Resistors .................................................................................. 37
3.6 A-D Conversion Bypass Capacitors ............................................................................................ 38
3.7 Connecting the PC4701 ............................................................................................................... 39
(1) Connecting the Cable to the PC4701 .................................................................................... 39
(2) Connecting the Cable to the Emulation Pod ......................................................................... 40
3.8 Connecting the Target System ..................................................................................................... 41
(1) Connecting to a 100-pin LCC Socket ................................................................................... 42
(2) Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 1) ............................................. 43
(3) Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 2) ............................................. 44
(4) Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 3) ............................................. 45