Renesas Emulation Pod M306N4T3-RPD-E, User Manual

Page: 22 / 76

( 22 / 76 )
* Please keep the M306N4T3-RPD-E's packing box and cushion material in your place for reuse
at a later time when sending your product for repair or other purposes. Always use these packing
box and cushion material when transporting this product.
* If any of these items are missing or found faulty, please contact your local distributor.
* If there is any question or doubt about the packaged product, contact your local distributor.
* For purchasing the IC61-1004-051 or for technical information, contact Yamaichi Electronics
Co., Ltd.
2.2 Other Tool Products Required for Development
To bring forward programs development on M16C/6N4, 6N5 MCUs of the M16C/6N Group , the
products listed below are necessary in addition to those contained package above. Get them
separately.
Table 2.2 Other tool products
* To purchase these products, contact your local distributor.
Chapter 2. Preparation
2.1 Package Components
The M306N4T3-RPD-E package consists of the following items. When unpacking, check to see if
your M306N4T3-RPD-E contains all of these items.
Table 2.1 Package components
Item
M306N4T3-RPD-E emulation pod main unit
FLX120-RPD flexible cable for connecting PC4701
M3T-F160T3-PRB converter board for M3T-FLX160C (preinstalled)
M30800T-PTC converter board for 100-pin 0.65-mm-pitch LCC
IC61-1004-051 100-pin 0.65-mm-pitch LCC socket (made by Yamaichi Electronics Co., Ltd.)
OSC-3 16MHz oscillator circuit board for main clock (preinstalled)
OSC-2 oscillator circuit board (bare board)
Resistor arrays for pulling up ports P0 to P5 (51 k
Ω
)
Hardware tool user registration FAX sheet (English/Japanese)
Repair request sheet (English/Japanese)
M306N4T3-RPD-E User's Manual (This manual)
M306N4T3-RPD-E User's Manual (Japanese)
Quantity
1
1
1
1
1
1
1
6
1 each
1 each
1
1
Emulator main unit
Emulator debugger
Converter board
PC4701 (excluding PC4701L and PC4700L)
M3T-PD30
For 100-pin 0.65-mm-pitch QFP (100P6S-A):
M3T-100LCC-DMS + M3T-DIRECT100S
M3T-100LCC-DMS + M3T-DUMMY100S
M3T-100LCC-DMS + M3T-FLX-100NRB
Required according to the foot pattern of the target system (see "3.8
Connecting the Target System" on page 41)