1. Description
This accessory tool connects an emulation pod and the target. It can be mounted on the same
foot pattern as the MCU housed in the 80-pin 0.65mm
pitch QFP.
It is applicable to the M16C and 740 Family, etc.
2. Package Components
(see Figure 1)
(1) DIRECT80S main unit (16.8x16.8mm)
(2) DIRECT80S User's Manual (this manual)
Figure 1 Package components of M3T-DIRECT80S
M3T-DIRECT80S main unit
(2/4)
4. Application
(see Figure 2)
Mount this dummy IC on the foot pattern on the target.
Then connect the emulation pod at the top of dummy IC.
Figure 2 Usage of M3T-DIRECT80S
M3T-DIRECT80S
Emulator
3. Specifications
Table 1 Specifications
5. Target Foot Pattern
Figure 3 shows the recommended foot pattern of M3T-DIRECT80S.
Before using M3T-DIRECT80S, be sure to read the
precautions on page 3.
: position of No 1 pin
Be sure to match the position of
No. 1 pin of the foot pattern and
each part.
Figure 3 Recommended foot pattern of M3T-DIRECT80S
12.35
0.65±0.05
0.35±0.05
14.6
Min. 17.5
12
.3
5
0.6
5
0
.35
1
4.6
Min
. 1
7.5
Note: The recommended foot pattern of M3T-DIRECT80S is a common foot pattern for 80P6
S-A and M3T-DIRECT80S. For DUMMY80S, use the foot pattern recommended by
Matsushita Electric Works, Ltd. shown in the DUMMY80S User's Manual.
Item
Max. current
Insulation resistance
200mA, 5V
100M
Ω
or over
(80-pin 0.65mm-pitch QFP)
Description
Package
Insertion/removal
iterations of connector
20 times guaranteed
PRQP0080JA-A (formerly: 80P6S-A)
