
VILLAGIO OWNERS MANUAL
Renegade RV
574.848.1126
Page 47
Rev.712a
This owner’s manual is subject to change
Updates will be posted on our web site
AT WWW. Renegaderv.com
Gen Start-
Gen Stop-
Gen Hour meter
Typical - Your coach may or may not be
equipped with all of the features shown above.
Water And Holding Tank Levels
Press the Tank Levels switch to show approximate levels on
the LCD screen.
Tank Levels Switch
The approximate fluid levels are measured by electronic sensors on the sides of the tanks. Tank
levels are displayed as 1/3, 2/3, and Full (F).
There is generally more fluid in a tank than indicated on the monitor panel.
Sensors,
Tank Capacities,
Water Tank
-Typical Villagio
See "Tank Capacities" in Section 1 -
Introduction.
Propane Gas Level
Press the Tank Levels switch to show
approximate propane tank level. The propane level is registered by a sending unit on the tank.
The gauge mounted on the side of the tank will give a more accurate indication of actual tank
level if needed.
Battery Charge Meter
Press the Battery Levels switch to check the level of charge (voltage) in the chassis and house
batteries.
Battery Levels Switch
To get an accurate reading:
Both the chassis engine and the generator engine must be shut off
and 120-volt AC shoreline unplugged.
An interior light should be turned on to
provide a small load which draws off the
battery surface charge.
Water Heater Switches
See Water Heater information elsewhere in this section for operating instructions.
Water Pump Switch
When use of the self-contained water system is desired, press the Pump switch (press once to
get to the desired screen, and a second time to activate or deactivate.) Water will be available
as soon as a faucet is opened.
Water Pump Switch
Refer to Section 7 - Plumbing for additional
information on the water pump and initial start
4-6 WATER HEATER
– GAS/