RCD Unit (residual current device)
This is located in a cupboard underneath sink/ hob area. This
can be accidently knocked as located behind pots, pans etc.
If you experience no 240v power please check to make sure
the switch is on. i.e switch is in the ‘up’ position.
If this is tripped or knocked accidently then the 240V supply
will not work.
Gas Isolation Switches (located in the cupboard underneath the sink)
These switches isolate various gas functions on board the motorhome.
The switch which has a picture of a pan is for your gas hob and should
always
be in the horizontal position.
The switch which has a picture of a tap/boiler is for your water boiler and should
always
be in the horizontal position.
The switch which has a picture of a snow flake is for your gas
supply to the fridge. Just go isolates this for safety reasons
and should always be in the vertical position. If you find you
are without power for the whole duration of your hire i.e
Festivals, you can phone the office and we can guide you
through running your fridge on gas (see fridge section below).
Plug Socket
The plug socket will only work if you are connected to a 240V electrical
hook-up source or a Just go generator.
Note: The plug socket will not work when you are travelling.
Heating System
Your heater has 2 different settings to heat the motorhome. You have a main heater and hot blown
air vents around the motorhome which is controlled by a switch on the main heater on the left hand
side.
To switch on heating:
Turn on gas. Make sure right hand thermostat dial is turned up to 10
and press the whole dial down. Hold the dial down until the boiler ignites, you will be able to
see the pilot light through the small window on the front of the heater. Once ignited, you can
turn the thermostat dial to the desired setting.
To heat from the main heater –
move the switch on the left hand side dial to the A setting
and use the thermostat to control the temperature
To heat from the hot blown air vents –
move the switch on the left hand side dial to the
far left on the setting that looks like a sharks fin. Use the left hand dial to control the amount
of air that is blown out of the vents.
To switch heating off:
Turn both dials to the lowest setting and move the switch on the left
hand side dial to the circle.
Never leave heating system on whilst the motorhome is moving, unattended or you are
asleep!
Main
Heater
Hot
blown
air
vents
Off
