Assembly instructions and
use of child safety devices
Headrail installation
1. Mark bracket hole positions on the wall or
ceiling (
fig
1
).
2. Drill holes and fix bracket in place using screws
provided.
3. Take the assembled blind & headrail and detach
the top of the blind from the headrail (
fig
).
4. Place the headrail profile up to brackets. Tilt
the headrail forwards and insert into bracket,
then tilt back to the straight position to ensure
the bracket has ‘clicked’ firmly in place (
fig
2
).
5. Secure the headrail by moving the locking arms
into place (
fig
).
6. Affix the top of the blind back to the headrail
(
fig
).
Ceiling Fix
Wall Fix
NOTE: Safety devices must be used
to ‘Make It Safe’ for compliance
1.
Place the blind face down and place the rail onto
the soft loop tape heading on your blind
(see
fig
below)
. Line-up the cord rollers – to adjust
positions twist the lock mechanism to unlock and
twist back to re-lock in the desired place. Ensure
all cords are fully unwound and equal length.
2.
Clip the
Clip-In Adjustable Cord Stoppers with
Hole
into the tape on bottom fold
(
fig
1
)
.
Alternatively you can sew-in to the bottom fold
through the small hole in the Cord Stopper close
to the clip
(
fig
2
)
–
See the back page of these
instructions for full positioning details.
3.
Thread cords through the guides in the tape which
has been sewn on to each of the folds in the rear
of the Blind and then through the main hole in the
Clip-In Adjustable Cord Stopper with Hole.
4.
Do NOT tie a knot in the lifting cords as this will
compromise the safety feature of the device.
5.
Confirm chain is the correct drop for the fitting
requirements and safety compliance – change if
required. Ensure the Safety Cord Guide is fitted.
Clip-In Adjustable Cord
Stoppers with Hole
Strong compression
spring to clamp cord
Clip the
Stopper to
blind here
Blind cord threads
through this main hole
Fig 2b
1
2
1
2
1
2
rca-uk.com
1
2
1
2
