REMS Cento, Instruction Manual

Page: 13 / 132

6. Disposal
REMS Cento , REMS Cento RF and REMS DueCento may not be thrown in
the domestic waste when no longer used. The machines must be disposed of
properly by law.
7. Manufacturer’s Warranty
The warranty period shall be 12 months from delivery of the new product to the
fi rst user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference in an unassembled condition. Replaced products and parts
shall become the property of REMS.
The user shall be responsible for the cost of shipping and returning the product.
The legal rights of the user, in particular the right to make claims against the
seller under the warranty terms, shall not be affected. This manufacturer's
warranty only applies for new products which are purchased in the European
Union, in Norway or in Switzerland.
This warranty is subject to German law with the exclusion of the United Nations
Convention on Contracts for the International Sales of Goods (CISG).
8. Spare parts lists
For spare parts lists, see www.rems.de → Downloads → Parts lists.
eng eng
5.6. Fault: Cutting wheel becomes blunt or breaks out after 1 or 2 cuts.
Cause: Remedy:
● Cutting in a cutting notch in which the previous cutting wheel already
became blunt or was damaged.
● Place the cutting wheel next to the notch with the remaining fragments.
● Unsuitable cutting wheel. ● Select and change cutting wheel according to the pipe to be cut.
● Pipe material is unsuitable for cutting. ● Only use approved pipes, see 1.3.
5.7. Fault: Cutting of the pipes leaves marks on the outside of the pipes.
Cause: Remedy:
● Rollers (3) of the pipe cutting machine and/or the roller insert (14) soiled. ● Clean rollers with machine cleaner REMS CleanM (Art. No. 140119),
then protect against rust.
● Rollers (3) of the pipe cutting machine and/or the roller insert (14)
damaged.
● Change rollers.
5.8. Fault: A wavy cutting edge is made when cutting stainless steel drainpipes/downpipes (EN 1124) with REMS Cento RF.
Cause: Remedy:
● Feeding pressure too high. ● Reduce feeding pressure.
● Blunt/broken cutting wheel. ● Change cutting wheel.
● Unsuitable cutting wheel. ● Use REMS cutting wheel RF (Art. No. 845054).
13