background image

 

Page 8 of 9 

Certifications 

UL Listed: 

This power unit is intended to be correctly orientated in a vertical or floor mount position. 

FCC Information 

FCC ID : 

TBD

 

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 

(1) this device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that may cause undesired 

operation.   

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no guarantee that interference 

will not occur in a particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

- Consult the dealer or an experienced radio/TV technician for help.

 

Notice : Changes or modifications to this unit not expressly approved by the party responsible for 

compliance could void the user authority to operate the equipment. 

 

IC information 

IC : 

TBD 

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to 

the following two conditions: 

(1) This device may not cause interference, and 

(2) This device must accept any interference, including interference that may cause undesired 

operation of the device.   

 

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts 

de licence. L'exploitation est autorisée aux deux conditionssuivantes: 

(1) l'appareil ne doit pas produire de brouillage, et 

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est 

susceptible d'en compromettre le fonctionnement. 

 

 

Summary of Contents for ZRP-120NA










Reviews: