Page 5 of 9
Z-Wave setup and operations
Include/Exclude ZRP-120 to/from a Z-Wave Gateway
Include or Exclude the ZRP-120 from the existing Z-Wave Home Control Network with
your primary controller.
-
Refer to your primary controller instructions to process the inclusion / exclusion
setup procedure.
-
When prompted by your primary controller, triple click the PROG button within 1
second.
-
The primary controller should indicate that the action was successful. If the
controller indicates the action was unsuccessful, please repeat the procedure.
Notes:
1, It is recommended to perform the Remove (Exclude) procedure before performing an Add
(Include) procedure.
2, The unit will enter classical inclusion/exclusion first, then jump to NWI, and after 20
seconds, it will finally exit NWI mode automatically if there is no inclusion/exclusion
request.)
3, ZRP-120 will not support Basic Command Class
4, All configuration parameters value will keep no change after exclude the unit from network
5, ZRP-120 can be included and operated in any Z-Wave network with other Z-Wave certified
devices from other manufacturers and/or other applications.
The Below listed Command Class are all supported the Security S2
COMMAND_CLASS_ASSOCIATION
COMMAND_CLASS_ASSOCIATION_GRP_INFO
COMMAND_CLASS_DEVICE_RESET_LOCALLY
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_SUPERVISION
COMMAND_CLASS_VERSION
LED Indication Status
Operations
LED Indication Status
Device not currently paired into
a Z-Wave network
LED will continuously flash two times per second.
Learning / NWI mode:
Triple click on PROG button
If the device already existing in the network, LED will flash slowly
for 20 seconds, and then return to previous ON or OFF stage.
If the device does not exist in the network, LED will keep flash
slowly and waiting for Network Wide Inclusion (NWI)
(The device will exit NWI mode automatically after 20 seconds)
