P.O Box 578 Casino, NSW, 2470 Australia
Phone: International ++614 2902 9083
Australia (04) 2902 9083
Website:
http://rcs-rc.com
E mail:
ALPHA
-3
(DELTANG DSM2 R/C Rx65-2).
E
lectronic
S
peed
C
ontroller
Supplied as:
Version “A” Ch # 5 triggers pad # 3.
Ch # 4 (low) triggers pad # 4.
Version “B” Ch # 2 (low) triggers pad # 3.
Ch # 4 (low) triggers pad # 4.
TABLE OF CONTENTS
PROVIDED IN INSTRUCTIONS.
Page # 1 Introduction.
Page # 2 Installing the
#
ALPHA
-3
ESC.
Page # 3 Operating the
#
ALPHA
-3
ESC.
Page # 4 Setting up the system. Binding the RX.
PLEASE NOTE. PDF WIRING INSTRUCTIONS ARE HERE:
http://www.rcs-rc.com/pages/instructions
INSTRUCTIONS.
Thank you for purchasing this Microprocessor based
E
lectronic
S
peed
C
ontrol
(ESC)
R/C system.
THIS NEW SYSTEM CAN USE ANY DSM2 R/C WITH 4 OR MORE CHANNELS.
THE
RCS
#
ALPHA
-3
SYSTEM IS IN ONE PART. THERE IS A BUILT IN 2.4 Ghz RX.
SERVO LEADS ARE NOT NEEDED.
THE
#
ALPHA
-3
IS A REPRAMMED DELTANG R/C Rx65-2.
THE SYSTEM IS READY TO USE AS IS, ONCE THE RX IS “BOUND” TO THE TX.
THE
#
ALPHA
-3
USES A “LOW OFF” CONTROL METHOD. THIS CAN BE CHANGED TO “CENTRE OFF”.
THIS IS ONE OF THE MANY FEATURES WITHIN THE SYSTEM WHICH CAN BE RE-PROGRAMMED.
USERS CONTEMPLATING ALTERING THE OPERATING CHARACTERISTICTS SHOULD THOROUGHLY
READ UP ON HOW TO DO SO
BEFORE
ATTEMPTING TO MAKE CHANGES:
http://www.deltang.co.uk/rx65a-v610-p.htm
IF YOU MESS IT UP WE CAN FIX IT FOR THE COST OF POSTAGE.
DO NOT CONNECT TO MAINS POWER (110 – 240V AC).
THE
#
ALPHA
-3
CAN BE USED WITH BATTERY POWER ONLY.
THEY HAVE CONSTANT BRIGHTNESS DIRECTIONAL LIGHTS & 2 x SOUND TRIGGERS.
USE 5v – 18v
ABSOLUTE MAXIMUM
FOR THE
#
ALPHA
-3
.
TAKE INTO ACCOUNT FULLY CHARGED BATTERIES CAN & DO EXCEED THE
NOMINAL
VOLTAGE.
VOLTAGE DROP FROM IN – OUT IS ABOUT ½ A VOLT UNDER A LIGHT LOAD.
We tested this system three times during manufacture. It was working normally when it left the factory.
If damage in transit has occurred, please return to place of purchase for attention.
THIS ESC IS GUARANTEED FOR ONE YEAR.
You will supply the DSM2 2.4 Ghz 4 channel (or more) Digital Proportional R/C TX handpiece.
You will also supply a locomotive or trail car, the 5 – 18 volt traction batteries, a fuse,
ON-OFF switch and wires where necessary, to connect the ESC to the battery and motor(s).
Where soldering is necessary, we recommend a low wattage soldering iron and resin core solder.
WE SUGGEST YOU MARK THE TX TO SHOW WHICH LOCO IT OPERATES.
CAUTION
DO NOT ATTEMPT TO ALTER THE TUNING OF THE RADIO EQUIPMENT.
DO NOT USE RADIO CONTROL EQUIPMENT IN THUNDERSTORMS.
CHILDREN UNDER 12: ADULT SUPERVISION RECOMMENDED DURING USE.
