REMKO SKT 261, Operating And Installation Instructions

Page: 13 / 56

4.3 Keys on the remote control
6
8
11
14 7
9
10
12
13
2
1
4
3
5
Fig. 6: Keys on the remote control
1
"ON/OFF" key
Press this key to switch the air conditioning unit on
and off.
2
"MODE" key
Operating mode selection. This key is used to set
the desired operating mode. The automatic,
cooling, dehumidification, heating and recirculation
modes are available.
3
"FAN" key
Fan speed Use this key to select the desired fan
speed. The automatic, low, medium and high func-
tions are available. Note: In the dehumidification
operating mode, the fan speed cannot be set man-
ually.
4
"SLEEP" key
Activates/deactivates the "SLEEP" function.
Pressing this key will automatically increase or
decrease the target temperature by 1 °C within an
hour in cooling and heating mode respectively.
Press this key to maintain the most convenient
temperature and save energy. This function is only
available in "Cooling", "Heating" and "Auto" modes.
If the unit is working in "SLEEP" mode, this activity
is interrupted by pressing the "MODE", "FAN",
"Speed" or "ON/OFF" keys.
5
"FRESH" key (without function)
6
"TURBO" key (without function)
7
"SELF CLEAN" key (without function)
8
"UP ARROW" and "DOWN ARROW" keys
Press this key to increase the setpoint in steps of 1
°C up to a maximum of 30°C.
Press this key to decrease the setpoint in steps of
1°C to a minimum of 17°C.
9
„SILENCE/FP“ key
Activates/deactivates the silent mode. Pressing the
key for longer than 2 seconds activates the unit's
frost protection function.
In silent unit mode, the compressor runs at a lower
frequency, and the indoor unit fan rotates at a
slower speed. This obtains particularly silent unit
operation.
The frost protection function can only be activated
in heating mode. The unit operates with a fixed
setpoint of 8°C. The indoor unit displays "FP".
Pressing the ON/OFF, SLEEP, FP, Mode, FAN or
up or down arrow key, the frost protection function
is deactivated. Press the this key to activate the
unit start delay time.
Note please!
Both functions are not available when con-
necting to the MVT unit series!
13