REMKO LWM 110, Operating And Installation Instructions, Page: 53 / 64

12 Commissioning
The Smart-Control Touch is used to operate and
control the complete heating system. The Smart-
Control Touch is operated via the touch display.
n The unit is pre-installed at the factory. After a
reset of the Smart-Control Touch, the default
parameters are loaded.
n An intensive visual inspection is to be carried
out before the actual commissioning.
n Switch on the power supply.
n Then the pre-installed data is loaded and the
parameters can be set with the help of the
commissioning wizard or in the system configu-
ration. You can find information on this in the
separate operating instructions of the Smart-
Control Touch.
NOTICE!
Before commissioning the entire system,
including hot water tank, must be filled!
Overview of the controls
1 2 3 4
Fig. 44: Controls of the Smart Control Touch
1: Overview (quick access)
2: Information (quick access)
3: Settings (quick access)
4: Messages (warnings, information notes and
errors)
Function display
Unit operation is intuitive and self-explanatory via
the plain text display on the user interface on the
touch display. No buttons are required to adjust
and change parameters. Instead, this takes place
by touching the surface of the controller at the
appropriate points. The installation of further func-
tions such as KNX or Smart-Web is possible
through the installation of further supplementary
software available as an accessory.
You can access the expert level by touching the
REMKO logo in the upper right corner of the dis-
play. After entering the password (0321) using the
+/- combination and then touching the "Next" and
"OK" displays, the expert level is enabled.
53