REMKO EFS 25, Assembly And Operating Instructions Manual

Page: 29 / 36

7 Commissioning
DANGER!
Danger of death due to electric shock!
Before initial commissioning, carry out all of the
tasks described in Ä Chapter 5 ‘Assembly and
dismantling’ on page 23 and
Ä
Chapter
6 ‘Electrical wiring’ on page 25 completely.
– After the unit has been disconnected from
the mains for a long time, the date and time
must be set again when switching on (see
steps 1-5 below).
– Saved functions that are not connected to
a time setting remain set even after an
extended power failure (> 15 minutes).
The controller is pre-set when it is manufac-
tured. You only have to set the date and time
(Fig. 33).
T
Fig. 33: Setting the time
T: Time
For information about operation, refer to
Values can be changed retroactively within con-
trolled operation. The following applies:
n " s /ESC/ r " navigates forwards and backwards
block by block
(Fig. 33: " s " = forwards; "ESC/ r " = backwards).
n Navigating (with " s /ESC/ r ") is always pos-
sible after completing a block.
n Retroactive changes to a block are initiated
using "SET".
You can bring the controller into operation as
follows:
1. Set up the power supply to the controller.
- The time 12:00 is displayed.
- 12 flashes (Fig. 34)
2. Press " sr " to set the hour.
3. Press "SET". The minute flashes.
4. Press " sr " to set the minutes.
5. Press "SET".
6. Repeat steps 4 and 5 to set the year, month
and date.
Fig. 34: Setting the time
29