7
REPLACING THE CUTTERS
•
Ensure the shaver is switched off and open the foil holder (as above).
•
Grasp the flat edges of the cutter between your thumb and forefinger and pull
upwards.
•
To reassemble the cutter, insert the protruding pin on the shaver head into the hole
in the middle of the cutter. Gently push the cutter down, until it clicks in place.
•
Reassemble the foil holder and shaver head by securely snapping in place.
BATTERY REMOVAL
The battery must be removed from the appliance before it is scrapped.
The appliance must be removed from the charging stand when removing the battery.
•
Ensure the battery is discharged.
•
On the back of the shaver, press the shaving head release button to the right, grip
the head and remove the shaving head.
•
Using a small screwdriver, remove the 4 screws from the inside top of the shaver
and the single screw from the bottom of the shaver.
•
Separate the top and bottom housing.
•
Push the inner frame up and out through the centre of the top housing.
•
Prise out the batteries from the inner frame.
•
Cut or break the wire stamps on both ends of the batteries.
•
The batteries are to be disposed of safely.
ADAPTER SPECIFICATIONS
Manufacturer address and
registration number
Spectrum Brands (UK) Limited, Regent Mill, Fir Street,
Failsworth, Manchester M35 0HS
Company number: 02394603
Adapter model number
PA-04701U
Input voltage
100 - 240 V~
Input AC Frequency
50/60Hz
Output voltage
4.7 V
D
Output current
0.1 A
Output power
0.47 W
Average active efficiency
≥40.4%
Efficiency at 10%
-
No load power consumption
≤0.1W
