![background image](http://html1.mh-extra.com/html/remington/wdf-5030/wdf-5030_quick-start-manual_1437691006.webp)
6
•
Remove the shaver head assembly by sliding and holding the shaver head release
button on the back of the shaver to the right. At the same time pull the shaver head
assembly firmly to remove (Fig. 2).
•
Brush or rinse any accumulated hair from the main body of the shaver, head
assembly, foil holder and cutter assembly.
•
Leave the head assembly and foil holder open to let the shaver dry
completely.
•
Reassemble the shaver head and body by sliding and holding the shaving head
release button to the right and securely snapping the head back onto the body (Fig.
3).
•
Reassemble the foil holder to the shaver head by securely snapping into place.
•
Do not rinse with water hotter than 70°C.
•
Do not submerge the appliance.
•
Do not clean the shaving foil with a brush.
•
At regular intervals, put a drop of sewing machine oil onto the foils and cutters
head. Remove excess oil.
REPLACING THE FOILS AND CUTTERS
•
To ensure the continued highest quality performance from your shaver, we
recommend that the foil and cutter are replaced every 6 months. These can be
obtained from your nearest Remington Service Centre.
SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING
•
Irritation: as foils get worn, you may experience skin irritation.
•
Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling through your hair.
•
Wear through: you may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL
•
Ensure the shaver is switched off.
•
Firmly press the foil holder release buttons at either end of the foil. The foil holder
should then easily detach from the head assembly.
•
Hold the foil holder with the foils facing towards you. Place your thumbs on each
side of the foil plastic guards and press firmly until the foil snaps free. Repeat this for
the second foil.
•
To reassemble turn over the foil holder. Position the new replacement foils in the
foil holder and pressing gently, click them into place.
•
Reassemble the foil holder and the shaver head by securely snapping in place.
CAUTION
•
Only hold the plastic to prevent damage to the foil.
•
Do not press on the foil when replacing.