NOTE:
• Ensure that the shaver is turned off when cleaning.
• Do not clean the shaving foils with the brush.
• At regular intervals, put a drop of sewing machine oil onto the foils and
cutters head.
REPLACING THE FOILS & CUTTERS
Signs that your foils and cutters need replacing:
Irritation:
As foils get worn, you may experience skin irritation.
Pulling:
As the cutters wear, your shave may not feel as close and you may
feel your cutter pulling on your hair.
Wear:
You may notice that the cutters have worn through the foils.
To ensure the continued highest quality performance from your shaver, we
recommend that foils and cutters are replaced every 6 months.
NOTE: The replacement part for your shaver model is SPW-488AU.
TO REPLACE THE FOIL
1. Ensure the shaver is switched off.
2. Remove the shaver head.
3. Gently push the small plastic tabs area at either end
of the foil carrier. The foil carrier should then easily
detach from the shaving head.
4. To reassemble, snap the new foil carrier into position.
5. Attach the shaving head.
CAUTION
• Only hold the plastic to prevent damage to the foil.
• Do not press on the foil when replacing.
TO REPLACE THE CUTTERS
1. Ensure the shaver is switched off and open the shaving head.
2. To remove cutter, grasp cutter between thumb and forefinger and pull
upward.
3. To reassemble cutter, place cutter onto oscillator tip. Gently push down
clicking into position.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
new foil
tabs
6
