12
|
6
troubleshooting
WARNING: Unplug blower/vac from power source before servicing. Severe
injury or death could occur from fire, electrical shock, or rotating impeller.
OBSERVED FAULT
POSSIBLE CAUSE
REMEDY
Motor does not run when you turn on/off
switch low or high
1. Bottom inlet cover or vacuum tube
adapter not locked into place
2. Extension cord connection is loose
1. Check inlet cover or vacuum tube
adapter for proper installation (see
blower/vac assembly,
page 4)
2. Check cord connection at electrical
outlet and at rear of blower/vac
Motor runs, but vacuum will not pick
up debris
1. Clogged vacuum tube or impeller
2. Vacuum bag full
1. Follow steps under
Removing
Clogged Debris from the Impeller,
page 10
2. Empty vacuum bag (see
Emptying
the Vacuum Bag,
page 10
Blower/vac vibrates excessively and/or
makes abnormal noises
Clogged vacuum tube or impeller
Follow steps under
Removing Clogged
Debris from the Impeller,
page 10
Note:
For additional help, visit
www.remingtonpowertools.com.
