![background image](http://html1.mh-extra.com/html/remington/rem-16-ttc-o/rem-16-ttc-o_users-manual-and-operating-instructions_1438380009.webp)
NEVER LEAVE HEATER UNATTENDED
WHILE BURNING OR WHILE CONNECTED
TO A FUEL SOURCE
© 2018 Pinnacle Climate Technologies, Inc.
Propane Tank Top Heater User’s Manual
9
ASSEMBLY
REM-47-TTC-O (Continued):
– To have all 3 burners face front, the plane
washer should be to the right side of tank
collar bracket (see Figure 3).
– To have far left burner face back, the plane
washer should be to the left side of tank
collar bracket (see Figure 3).
Figure 3
Connecting Heater to LP Cylinder:
Be sure to read and understand all of the
Safety Information in this manual before
connecting the heater to the LP cylinder.
Installation must conform to local codes and
with the Standard for the Storage and Handling
of Liquefied Petroleum Gasses and ANSI/NFPA
58.
Inspect the hose and regulator prior to each
use of the heater. If there is excessive abrasion
or wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list prior to
using the heater.
Model REM-16-TTC-O:
1. Be sure that the control knob on the regulator
is in the “OFF” position.
2. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful
not to over tighten.
3. Slowly open the LP cylinder valve.
Models REM-32-TTC-O / REM-47-TTC-O:
1. Be sure that the control knob on the regulator
is in the “OFF” position.
2. Line up the slots in the tank collar bracket
with the tank collar ring and slide into place.
Be sure the mounting knob is to the outside,
and tighten.
3. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful
not to over tighten.
4. Slowly open the LP cylinder valve.
Check all connections for leaks using a
50/50 mixture of dish-soap and water. Any
bubbles that appear show a leak. Remove and
reconnect the Connector Nut to the valve
.
DO NOT direct the heater dis-
charge towards any propane
cylinder located within 20 feet of the heater.
WARNING