7
,
DAILY
• Ensure the shaver is switched off and unplugged from the mains.
• Open the shaver head by pressing the release button on the front of the
shaver (Fig. I) and flipping open the head away from the body of the shaver
(Fig. J).
• Rinse the shaver head with warm water (Fig. K).
• Close head assembly (Fig. L).
,
WEEKLY
•
Perform the daily cleaning steps first.
• Open the shaver head by pressing the release button on the front of the
shaver and flipping open the head away from the body of the shaver.
• Release the inner cutter carrier by rotating the locking arms anti-clockwise.
• Pull the inner cutter carrier away from the inner cutters.
• Thoroughly brush hairs from the inner and outer cutters and rinse out any
remaining debris.
• Replace the inner cutter.
• Place the inner cutter carrier back onto the upper hair pocket and lock into
place by rotating the locking arms clockwise until the arms ‘click’ into place.
,
CAUTION:
• Do not submerge in water as damage will occur.
• The shaver can be rinsed with water.
• The water temperature should not exceed 70 degrees.
• Unplug the shaver before cleaning with water.
• Keep the adaptor and cable dry.
,
CLEANING TRIMMER
•
Lubricate the teeth of the trimmer every six months with a drop of sewing
machine oil.
,
TROUBLESHOOTING
• If your shaver battery is completely empty or the shaver has not been used
for an extended period of time, the shaver may not start when operated
using the cord. If this occurs, charge the shaver for approximately 15 seconds
before shaving.
• Your shaver should be mainly used in cordless mode and only recharged
when battery charge is low. Continuous connection to the mains will result in
the reduction of the battery life.
