Leave the shaving unit open to let the shaver dry completely.
At regular interval, put a drop of sewing machine oil onto the shaving head.
CAUTION: Do not clean the shaving foil with the brush.
REPLACING THE FOILS & CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that foils and cutters are
replaced regularly.
Signs that your foils and cutters need replacing:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may feel your cutter pulling your hair.
Wear through: You may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL
Hold the housing of the head assembly with one hand. Use a small flat blade screwdriver or similarly tipped blunt
object. From the inside opening, press upward on each release strap to push both screen assemblies out of the top
of the head assembly. (Fig. G)
Carefully slide two foil assemblies downward into the top openings. It is easiest if you lower one end first, hooking
the end in place, then swing the far end down until it snaps in place. (Fig. H)
If the foil assembly will not fit easily into the housing, rotate the foil 180 degrees.
TO REPLACE THE CUTTERS
Grasp cutter between thumb and forefinger and pull upward. (Fig. I)
Snap both new cutter assemblies into top of oscillator tips.
Note: Do not press on the cutter ends as this may cause damage.
(Fig. J)
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO
PERSONS:
Keep this product out of reach of children. The use of this appliance by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge can give cause to hazards. Persons responsible for their
safety should give explicit instructions or supervise the use of the appliance.
An appliance should never be left unattended when plugged in to a power outlet, except when charging.
Keep the power adaptor and cord away from heated surfaces.
ENGLISH
4
080086_REM_IFU_MS2291-2391 _UK.indd gb4
080086_REM_IFU_MS2291-2391 _UK.indd gb4
26.02.2008 15:48:55 Uhr
26.02.2008 15:48:55 Uhr
Foil replacement model: SP95.
Foil and cutters replacement model: SP96.
