Troubleshooting
The trimmer does not work when turned on:
■
Trimmer must be charged a minimum of 90 minutes, or use trimmer while
plugged into wall.
Trimmer cutters do not move:
■
The cutting unit may be dirty and clogged. Clean the unit as directed in
Cleaning & Maintaining section.
Trimmer does not hold charge:
■
Fully discharge battery by running trimmer until it stops; then follow recharg-
ing instructions (see section on Charging Your Trimmer).
Trimmer does not function properly, touch buttons not working:
■
Reset the product following instructions in How to Use section.
U.S. residents: To order accessories, contact us at 800-392-6544, visit us at www.
RemingtonProducts.com, or visit your local retailer.
Cleaning & Maintaining Your Trimmer
After each use:
■
Brush the accumulated hair from the cutters.
Do not submerge the trimmer
in water. This product is not washable.
Cleaning Cautions:
■
Do not expose this product to water, unit is not washable.
Storage
■
Always store this appliance and cord in a moisture-free area.
■
Do not wrap the cord of the charging adaptor around the appliance.
■
Do not store in temperatures above 140ºF.
Battery Removal
When your rechargeable trimmer reaches the end of its useful life, the batteries
must be removed and recycled or disposed of properly in accordance with your
local and state requirements.
The following procedure should be followed for battery removal:
Unplug the MB4550
■
Run down the trimmer battery;
■
Remove the “comb” attachment;
■
Detach the “blade head”;
■
Remove the “head clip” using a screw driver;
■
Using a screwdriver carefully pull out the “top housing”
■
Unscrew the six screws on the “motor bracket” then lift out the “bottom housing;
■
Remove the “upper circuit board”;
■
Cut the motor connecting wires and remove the “motor bracket”, “front
portion of the motor bracket”, “comb rail”, “middle motor”, and gear chains”;
■
Disconnect the batteries from the lower circuit board by solder-iron then remove;
■
The batteries are to be disposed of safely.
Battery
Cleaning & Maintenance
No responsibility, obligation, or liability is assumed for the installation or maintenance
of this product.
SPECTRUM BRANDS, INC. SHALL NOT BE RESPONSIBLE FOR ANY
INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE
USE OF THIS PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT
LIMITED TO IM PLIED WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE
LIMITED IN DURATION TO TWO YEARS FROM DATE OF ORIGINAL PURCHASE.
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state or province to province. Some states do not allow
the exclusion or limitation of incidental, special or consequential damages.
Spectrum Brands, Inc. Money-back Offer
If within 30 days after you have purchased your Remington
®
branded product,
you are not satisfied and would like a refund, return it with the sales slip indicat-
ing purchase price and date of purchase to the retailer from whom it was pur-
chased. Spectrum Brands, Inc. will reimburse all retailers who accept the product
within 30 days from the date of purchase. If you have any questions concerning
the money-back guarantee, please call 800-736-4648 in the US.
100-240 VAC 50-60 Hz
Questions or comments:
Call 800-736-4648 in the US
. or visit
www.RemingtonProducts.com.
Dist. by: Spectrum Brands, Inc., Madison, WI 53711
REMINGTON is a registered trademark of Spectrum Brands, Inc.,
or one of its subsidiaries.
© 2011 SBI
6/11 Job# CS41771_REV A
Manufactured to Remington’s specifications in the PRC.
T22-32687
Limited Two-Year Warranty
Spectrum Brands, Inc. warrants this product against any defects that are due to
faulty material or workmanship for a two-year period from the original date of
consumer purchase. This warranty does not include damage to the product
resulting from accident or misuse.
If the product should become defective within the warranty period, we will
replace it free of charge. Return your product with your name, address and day
time phone number to: Remington Returns Center, 507 Stokely Dr., P.O. Box 1,
Deforest, WI 53532. For more information call 800-736-4648 in the US.
This warranty does not cover products damaged by the following:
■
Accident, misuse, abuse or alteration of the product
■
Servicing by unauthorized persons
■
Use with unauthorized accessories
■
Connecting it to incorrect current and voltage
■
Wrapping cord around appliance causing premature wear & breakage
■
Any other conditions beyond our control
Warranty
Stubble
Goatee
Beard
1/16” (1.6mm)
3/16” (4.8mm)
3/8” (9.5mm)
1/8” (3.2mm)
1/4” (6.4mm)
1/2” (12.7mm)
–
5/16” (8.0mm)
5/8” (15.9mm)
–
–
11/16” (17.5mm)
Charging Your Trimmer
■
Trimmer must be turned off.
■
Insert the adapter plug into the bottom of the trimmer and plug the adapter
unit into a power outlet.
■
The trimmer has a typical charging time of 90 minutes.
■
The batteries cannot be overcharged, but it is recommend that charging be
discontinued if the trimmer will not be used for a long period of time. The
battery life indicator will show that the unit is charging. The LCD screen will
illuminate for several seconds before dimming, when fully charged, the
battery life indicator will show a full battery level and the LCD screen will
turn off.
■
It is advisable not to use this trimmer directly from the power outlet when
it has been fully charged, but if while using the trimmer in cordless mode
there is a noticeable drop in power, you can use directly from the power
outlet.
■
If the trimmer has not been used for a month or longer, it is advisable to
recharge it for 90 minutes.
■
To preserve the life of the batteries, discharge them by running the trimmer
until the blades move slowly. Switch off and fully recharge. Do this every
six months.
■
Charge the trimmer at temperatures between 40º and 90ºF.
■
Nickel-Metal Hydride batteries are included. See battery removal section for
proper disposal of batteries.
■
If trimmer battery is completely discharged and you desire to use the trimmer
in corded mode immediately, please note that there will be a 10 second delay
before the motor and LCD can be activated. There will also be a slightly
longer delay before the touch interface can be activated.
Touch Interface
■
The motorized comb can be adjusted by simply tapping the Touch Length
Control up or down arrows. You may also hold the arrow down to move the
comb continously. The LCD screen displays 0.1mm increments.
■
Motor speed can be adjusted by tapping the Touch Tri Speed icon.
Touch Tri Speed
There are 3 settings for the trimmer:
■
The trimmer will default to the lowest motor speed initially.
■
If more or less power is desired tap the Touch Tri Speed icon. Motor speed
level is displayed on LCD screen.
Touch Lock
■
Once your desired length and motor speed is set, lock the device by sliding
the switch in the lock position.
Product System Reset
The user will never have to force a system reset under normal conditions.
If the trimmer experiences abnormal behavior, such as low or high touch
sensitivity, the system can be reset.
■
Hold power button for 8 consecutive seconds.
■
System will show 18.8mm, full battery, full lock and full boost level.
■
Ensure no objects, hands or fingers are near the touch buttons.
■
Push the power button once.
■
Comb will travel down to 0.4mm.
■
Let the product sit until the screen dims.
■
Product is now ready, turn it on and confirm function.
Conversion Guide
How to Use
USB charging
■
Trimmer must be turned off.
■
Insert the USB cable into the bottom of your trimmer and the plug into
the USB port on your PC. The battery life indicator will show that the unit is
charging. The LCD screen will illuminate for several seconds before dimming,
when full charged, the battery life indicator will show a full battery level.
■
The trimmer has a typical charging time of 90 minutes.
■
Do not run trimmer when charging via USB port on your PC.
Contains
listed adaptor
