9
8
ENGLISH
ENGLISH
,
Bulb Status Indicator Display (fig. 1-8)
The device is ready to flash when the Bulb Status Indicator Display is illuminated green.
NOTE:
if the Flash Button is pressed AND the Skin Contact Sensor is not fully engaged OR the Bulb Status
Indicator Display is not illuminated, an audible “beep” will sound. When the Bulb Status Indicator Display
illuminates yellow, there are 150 flashes remaining in the flash bulb. When the Bulb Status Indicator Display
flashes yellow, the bulb cartridge has been used up and will no longer operate. You must replace the bulb
cartridge to continue using the device.
,
Treatment Head Release Buttons (fig. 1-14)
Press both buttons and gently pull to remove the treatment head.
F
WARNING:
ALWAYS ensure the unit is OFF and the power cord is disconnected before removing the nose
cone. If the nose cone is removed while the unit is powered ON, all indicator lights on the base unit will flash
and audible “beeps” will sound.
C
GETTING ACQUAINTED WITH i-LIGHT
,
Long-Life Light Cartridge (fig. 1-15)
The long-life light cartridge will deliver 65,000 flashes regardless of the energy level selected. While it is
unlikely you will ever need to replace it; it can be replaced by another long-life cartridge SP-6000FQ. Please
contact your local Remington® service centre.
,
Energy Level Selection (fig. 1-6)
The i-Light device is equipped with 5 energy levels. Level 1 is the lowest setting and level 5 is the highest
setting.
TIP:
For the most effective results, always use the highest energy level that does not cause discomfort on the
skin. To determine the energy level being used, observe the number of lights illuminated on the Energy
Level Display (fig 1 - 9).
Your i-Light device will automatically be set to Energy Level 1 each time the device is powered ON. To
change the level, press the Energy Level Selection Button.
,
Test the i-Light device on your skin
1. Review the Warnings and Safety Precautions.
2. Familiarise yourself with the features of the i-Light.
3. Consult the Skin Tone Chart to ensure your skin colour is in the acceptable range (fig. 5).
4. Place the skin of the intended treatment area onto the skin tone sensor - touching the skin tone
sensor (fig. 6).
If your skin is suitable, the appliance will beep and switch on.
If your skin is unsuitable, the appliance will buzz and remain off.
5. Test the i-Light device on a small patch of skin and wait 48 hours to ensure there are no adverse
reactions. (fig.7).
Fig. 5
Fig. 6
Fig. 7
,
Treat desired area(s) with the i-Light device
Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils, deodorants, perfume, make up, lotions and
creams. Shave or trim the hair from the area to be treated (fig 8).
2. Never use wax, epilation, tweezers or depilation products to remove the hair because they counteract
the IPL process.
Prepare the device for treatment
3. Unwrap the hand piece cord from the i-Light base and rest the hand piece in the base cradle. Locate
the power switch on the i-Light base and ensure the unit is OFF. Connect the power cord to the i-Light
base at the power inlet. Connect the power cord to the wall outlet. Turn the power switch ON. (fig. 9)
4. Use the skin sensor to unlock the unit (fig. 6).
You must unlock the unit on each body part you wish to treat.
5. Select the desired Energy Level. (fig. 10).
If your skin is unsuitable, the appliance will buzz and remain off.
Fig. 8
Fig. 9
Fig. 10
GB
D
NL
F
E
I
DK
S
FIN
P
SK