![background image](http://html1.mh-extra.com/html/remington/hh-600t-kfa/hh-600t-kfa_users-manual-and-operating-instructions_1438367009.webp)
© 2014 Pinnacle Products International, Inc.
9
Kerosene User’s Manual
Maintenance
Never service heater while it is plugged in
or while hot!
Use only original equipment replacement parts. The use of
alternate or third party components can cause unsafe operating
conditions, and will void your warranty.
We suggest following a maintenance schedule as follows:
FUEL/FUEL TANK:
Flush every 200 hours of operation or as needed. Do not use
water to flush the tank. Use fresh 1-K kerosene only.
AIR FILTERS:
The
Air Intake Filter
should be replaced or washed with soap and
water and dried thoroughly every 500 hours of operation, or less,
depending on conditions.
The
Output
and
Lint Filters
should be replaced every 500 hours
of operation or less, depending on conditions.
NOTE:
Use of diesel may require additional maintenance.
FAN BLADES:
CLEAN EVERY SEASON OR AS NEEDED.
- Remove upper shell (See air intake filter).
- Use Allen wrench to loosen set screw which holds fan blade to
motor shaft.
- Slip fan blade off motor shaft.
- Clean fan blade using soft cloth moistened with kerosene or sol-
vent.
- Dry fan blade thoroughly.
- Reinstall fan blade to motor shaft.
- Place fan hub flush with end of motor shaft.
- Place set screw on flat end of shaft.
- Tighten screw firmly (40-50 inch pounds/ 4.5-5.6 N-m). Reinstall
upper shell.
NOZZLE:
Remove dirt in nozzle as needed
- Remove upper shell.
- Remove fuel line B from burner assembly by using wrench.
- Remove burner head from burner assembly.
- Remove lead wire from spark plug.
- Remove spark plug from burner head.
- Carefully remove nozzle from burner head using socket wrench.
- Blow compressed air through face of nozzle (This will remove
any dirt).
- Inspect nozzle for damage. If damaged or clogged, replace
nozzle.
- Make sure plug is in place on burner head.
- Reinstall nozzle into burner head and tighten firmly (175-200
inch-pounds).
- Reinstall spark plug in burner head.
- Attach burner head to combustion chamber.
- Attach spark plug wire to spark plug
- Attach fuel line to burner head and tighten firmly.
- Replace upper shell.
- Attach ignitor wire to spark plug.
- Attach fuel and air line hoses to burner head.
- Reinstall fan blade and upper shell.
SPARK PLUG:
CLEAN AND REGAP EVERY 600 HOURS OF OPERATION OR
REPLACE AS NEEDED.
- Remove upper shell.
- Remove spark plug wire from spark plug.
- Remove spark plug from burner head using medium Phillips
screwdriver.
- Clean and regap spark plug electrodes to 0.1” (2.5 mm) gap.
- Reinstall spark plug into burner head.
- Attach spark plug wire to spark plug.
- Reinstall upper shell.
WARNING
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE
Figure 9:
Nozzle Replacement
Nozzle
Figure 10:
Spark Plug Replacement
Spark Plug
Nozzle