3. Again, work the Head Trim-Shave blade all over the head, with angled and even
strokes against the direction of hair growth.
4. As this blade captures the shortest of hairs, you may be required to tap the tip
of the blade throughout the shaving process to remove the small hairs that are
captured in the blade.
5. The Head Trim-Shave blade may be used directly if you are maintaining the shaved
look, it is not necessary to use the hair clipper blade unless your hair is long,
NOTE:
failure to first trim back long hair with the hair clipper blade may result in a
pulling sensation or missed hairs resulting in an undesirable result. Always use the Head
Trim-Shave blade with very short hair. The guard on the Head Trim-Shave blade cutters
is designed to gently stretch the skin while it is in use. The guard is not removable.
Should the guard become clogged with hairs during use simply tap it out or rinse it
under running water
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the
battery.
• Ensure the hair clipper is discharged of all power.
• Firstly, pry the detail blade head housing using a single-side screwdriver.
• Using a small screwdriver, unscrew 2 screws on the back housing of the hair
clipper.
• Continuously pry the front housing using the single-side screwdriver.
• Pry the PCB holder assembly again using the single-side screwdriver from the back
housing so you can see the PCB and batteries exposed.
• Destroy the PCB holder using a wire cutter, cut the tabs on both ends of the battery
assembly and remove the PCB.
• Dispose of the batteries safely
This product is not suitable to use in a bath or shower
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
8
