7
STEP 4 - TOP OF THE HEAD - DIAGRAM D
•
With setting 4 (15mm), cut hair on top of the head against the direction in which the
hair normally grows.
•
For longer hair on top either use the 18mm attachment guide comb or use without
a guide comb.
•
If using without a guide comb lift the hair on top of the head with a small hand
comb. Cut over the hand comb with the hair lifted or hold the hair between the
fingers to lift it and cut it to the desired length.
•
Always work from the back of the head.
STEP 5 - THE FINISHING TOUCHES - DIAGRAM E, F & G
•
Use the clipper without an attachment comb for close trimming around the base
and sides of the neck.
•
To produce a clean straight line at the sideburns, reverse the hair clipper.
•
Place the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality blades. To ensure long lasting performance of your
clipper, clean the blades and unit regularly.
AFTER EACH USE
•
Ensure the clipper is switched off and disconnected from the mains.
•
Turn the clipper to the backside.
•
Press both buttons located above the lock switch at the same time to open the hair
pocket (Diagram H).
•
Brush the accumulated hair from the blades and the hair pocket. Do not submerge
the clipper in water.
•
After cleaning close the hair pocket.
•
Place one or two drops of oil on the blades. Turn the clipper on to distribute the oil
evenly, wipe off any excess oil. Excess oil will cause damage to the product.
•
To clean the unit, wipe with a damp cloth and dry immediately.
•
NOTE: Ensure that the clipper is turned off when cleaning.
CLEANING CAUTIONS
•
Cleaning should only be done with a soft brush, such as the brush supplied with the
product.
•
Only use the light-grade oil supplied or sewing machine oil on the blades.
•
Do not use harsh or corrosive cleaners on the units or their blades.
•
Do not submerge in water as damage will occur.
