5
Roll the ‘Thumb Wheel’ anti-clockwise to adjust for a longer length. Roll it
clockwise to adjust for a shorter length. The wheel will click into one of five
positions.
• Begin trimming at one of the longest settings - #4 or #5 – to avoid accidentally
trimming hair too short. As you become familiar with the settings, you can then
select your desired length setting.
TRIMMER COMB ATTACHMENT
Remove the adjustable trimmer comb attachment if you are defining hairline edges
for shaping and trimming, or if you want to clean the cutter assembly.
To remove:
• Be sure that the trimmer switch is in the off position.
• While holding the trimmer in one hand with your thumb on the ‘Thumb Wheel’
to prevent it from turning, gently pull the trimmer comb attachment away from
the trimmer. The comb can be removed and replaced on any setting.
To replace:
• Be sure that the trimmer switch is in the off position.
• While holding the trimmer in one hand with your thumb on the ‘Thumb Wheel’
to prevent it from turning, slide the comb over the top of the trimmer until it
‘clicks’ into position.
Note: The trimmer comb attachment can only be placed on the trimmer one
way; if it does not fit properly, remove and reverse it.
HOW TO USE YOUR TRIMMER
• Hair should be dry.
• Ensure that the batteries are installed correctly.
• Set the ‘Thumb Wheel’ to the desired length setting – suggest start at #4 or
#5.
• Turn trimmer on.
• Place the flat top end of the trimmer comb against the skin.
• Slowly slide the trimmer through the hair to be trimmed. The hairs will feed
right into the comb tines.
• Repeat this trimming motion as necessary, adjusting to approach the desired
area from different directions.
• If, during the trimming process, hair builds up in the trimmer comb, shut the
unit off, pull off the adjustable trimmer comb and brush it off.
• For an even closer look and precise shaping, remove the adjustable trimmer
comb and trim the hairs along the outer edge of the intended area.
• When finished, turn the trimmer off and clean.
