16
OPERATION
Plug the fireplace into a 15 Amp wall socket.
MANUAL OPERATION
SAFETY CUT-OFF
This appliance is fitted with a safety cut
(e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT automatically
reset.
To reset the appliance, disconnect the appliance from the main supply for at least 10
minutes. Reconnect the supply to the main and switch on the appliance.
Plug the fireplace into a 15 Amp wall socket.
This appliance is fitted with a safety cut-off which will operate if the fireplace overheats
(e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT automatically
appliance, disconnect the appliance from the main supply for at least 10
minutes. Reconnect the supply to the main and switch on the appliance.
off which will operate if the fireplace overheats
(e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT automatically
appliance, disconnect the appliance from the main supply for at least 10
minutes. Reconnect the supply to the main and switch on the appliance.
The fireplace can be operated either by the touch panel located on the left front top side of
the fireplace, or by supplied remote control.
The fireplace can be operated either by the touch panel located on the left front top side of
or by supplied remote control.
The fireplace can be operated either by the touch panel located on the left front top side of
1. Press “
”, the flame light turns on, color yellow, color orange and color red are on
the brightest mode(Y4,O4,R4), the tray light in white (E3), indicating “ON” , heater is
not working. Press gain to turn off the appliance, indicating “OF” on display, the
display will disappear in 5 seconds. It will recall the last setting used on the fireplace
2. Press “ ” to adjust the flame color, F1 red, orange& yellow, F2 orange, F3 red, F4
yellow, F5 Red & orange, F6 orange & yellow, F7 red & yellow, F0 turns off the flame
light.
3. Press “ ” once, one setting of heater works, 750W, indicating “H1” on display;
Press again, two setting of heater work, 1500W, indicating “H2”. Press the third time,
the heater turns off, indicating “H0” on display. Press this button for 5 seconds,
indicating “LO”, heater is off and the button is locked. Press this button again for 5
seconds, indicating “UL”, heater is still not working but the button is unlocked.
4. Press “ ” to adjust the tray light. E0 means the tray light turns off. EE means the
color of tray light cycles through 13 colors with an interval of 1 minute.
5. Press “ ” to set the turn off time, 30-1h-2h-3h-4h-5h-6h-7h-8h-00.
Summary of Contents for WM-50-XS
Page 21: ...21 EXPLODED VIEW...
Page 24: ...24...
