9.2.4
Cleaning the exterior
Caution
Do not use any cleaning agents containing soda, acids, sand or
chlorine in order to protect the surface.
1. Clean the external parts of the device with a damp cloth and common
detergents.
10 Troubleshooting
10.1 General
Danger
Installation, maintenance and repairs must always be done by
an qualified technician in accordance with local legislation.
Always disconnect the device from the power source when you
perform maintenance.
Do a check of the complete installation for leakages after
service or maintenance.
Remove casings only for maintenance and service. Replace all
casings after maintenance or service.
Use only the fuse supplied or an identical fuse in case of a
defect fuse.
Use only original spare parts.
Caution
Always replace all gaskets carefully of all dismounted parts during
maintenance.
10.2 Errors
If an error occurs, an error code will be displayed on the controller of the
device.
See
Refer to the controller manual for explanation of the error codes.
If you cannot solve the problem, inform an approved installer or service
technician.
Additional information is available upon request at the BAXI service
desk.
Errors which are not displayed on the controller can be checked using the
following table. If the error cannot be solved, contact the installer or
service technician.
Fault
Possible cause
Solution
Display is not functioning
There is no mains power
Switch on or connect the controller
Inspect the house fuse for the connec
tion
The device is malfunctioning
Consult the installer
Controller is not working
The controller is in manual mode
Exit the Manual menu
The switch-on condition is not fulfilled
Wait until the switch-on condition is fulfil
led
The displayed temperature fluctuates
wildly at short intervals
The sensor lines are routed close to
230V cables
Route the sensor cables in a different
way and shield the sensor lines
There are long sensor lines without
shielding
Shield the sensor lines
The device is malfunctioning
Consult the installer
There is a loose sensor cable
Re tighten the sensor cable
10 Troubleshooting
38
7697291 - v.05 - 11032022
