Installation, start up and operating manual –
version 5.3 Gen.10
Radio control BRICK and PAIL
The led (ON) on the battery charger (see Fig. 4) indicates the correct
electricity feed.
To charge the batteries, switch off the transmitter unit by turning the key
to the OFF position and place the unit onto the battery charger housing,
taking care that the jutting out part in the middle of the battery charger
is properly inserted into the slot on the bottom of the transmitter unit, as
indicated by the double arrow in Figure 4.
The transmitter unit has an automatic cut off switch that activates when
the transmitter unit is placed onto the battery charger.
The flashing red led (BATT) on the transmitter unit indicates that the
batteries are being charged correctly.
Charging is controlled electronically: the charging time required is
recognised automatically.
When the batteries are completely recharged the red led (BATT) on the
transmitter unit becomes permanently lit.
With new and completely charged batteries the transmitter unit can be
operated for approximately 35 hours (of continuous use).
It is necessary to charge the batteries just once a week
(eg, at the weekend).
The electronic checking of the state of the charging process means it is
possible to leave the equipment on the battery charger for long periods
without causing any adverse affect to the battery.
It is normal for the jutting out part of the recharger and the
corresponding slot of the transmitter unit to become warm during the
charging process.
If the batteries are completely uncharged just place the transmitter unit
on the battery charger for 30 minutes in order to guarantee one working
day’s operation of the radio control unit.
DO NOT attempt to open the battery charger to carry out repairs: in the
event of a unit failure either contact an authorised agent or REMdevice
directly.
When not being used, unplug the recharging unit.
REM
device
®
- ITALY
9
