Installation, start up and operating manual –
version 5.3 Gen.10
Radio control BRICK and PAIL
It is advisable to further protect the casing further using non-metallic
material.
Fix the casing using the assembly KIT provided. The hole sizes are
shown in Figure 5.
Never make holes in the casing. Make sure the casing is properly fixed
by using only suitable safe means.
For any further information or advice regarding the correct
installation and starting up of the equipment contact REMdevice.
WARNING: DO NOT remove the receiver module from its sealed
casing in order to install it inside the machine’s electric panel.
To ensure the safe and correct wiring of the receiver use multipolar
cabling and plug of the same kind used for the cabled keypad provided
with the machine.
Use metal wire heads to clamp the conductors, then connect to the
terminals of the receiver and check they are properly tightened.
To facilitate wiring it is possible to take out the receiver module from the
casing by unhooking the DIN support bracket by lifting the lower tab (see
Figure 6).
Check that there is a suitable isolating device. Using a voltmeter, check
there is suitable current to the electric panel for the receiver module.
Information regarding the electrical current required can be found under
the TECHNICAL SPECIFICATIONS (it is also shown on the adhesive label
located on top of the clamps). The position of the phase and neutral or
positive and negative wires does not matter.
REM
device
®
- ITALY
11
