BA-KommCAN_EN / F0353400
June 2016
7
2.2.2
Scope of delivery
The scope of delivery includes the following components:
•
CAN cable (length 2 m)
•
CAN terminal resistor (Sub-D)
•
CAN terminal resistor bushing (Sub-D)
•
USB stick with EDS file
•
Operating instructions
2.2.3
Other hardware components needed
Depending on the PLC used, additional hardware components are needed for a functioning
overall system. Recommendations for this are listed below.
Components
Description
HMS CM CANopen-
master/slave module for
SIMATIC S7-1200 PLC
(021620-B)
This module can be used to establish communication
with the PS2000 current source when using a
SIMATIC S7-1200 PLC
.
Beckhoff EL6751 CANopen-
master/slave terminal
This module can be used to establish communication
with the PS2000 current source when using a
Beckhoff PLC
.
Other manufacturers of PLC modules offer comparable components for your systems.
3
Transport / storage
•
Protect the system from dirt and foreign objects.
•
Protect the system from impact.
4
Unpacking and installation
4.1
Unpacking
•
Carefully open the packaging.
•
Take the components out of the packaging.
4.2
Installation requirements
Before installing the machine, the following points must be met:
•
The components must be undamaged.
•
If installing as a permanent installation or in a building, a suitable switch or circuit
breaker that satisfies national safety requirements (in Germany: VDE 0100) must be
fitted as an upstream all-pole cut-off device that will disconnect the system from the
power supply. This cut-off device should be fitted near the machine and must be easily
accessible to the user. The switch must also be labelled as the cut-off device for the
machine.
•
Only a trained electrician may wire the system.
•
Observe all installation requirements and safety notices for the additional machines
connected.
