
RMV800 SERVICE MANUAL
-
23
-
(1) Turn on the source radio while holding down [PF5] simultaneously, the radio enters Clone Mode
with “CLONE” on the LCD, or enters User Mode if Clone Mode is set OFF by your dealer.
(2) Press [PF2] to toggle between Dealer Clone and Factory Clone Mode. “Dealer Clone” or
“Factory Clone” appears on the display when the corresponding mode is selected. The radio
returns to original display mode in 5 seconds.
Unlike Factory Clone Mode, adjustment settings and embedded messages are not covered in
Dealer Clone Mode.
Dealer Clone Mode is the default mode.
(3) Connect the two radios by clone cable, then turn on the target radio.
(4) Press [PF6] to start cloning, the LED of source radio glows red and that of target radio glows
green during cloning. “PROGRAMMING” is also displayed on the target radio. “END” appears on
the source radio when cloning is completed and the target radio reset when all data is received.
(5)
Press [PF6] to return to Clone Mode. “CLONE” appears on the source radio. Repeat the above
steps to continue wired cloning.
Note: Only the same models can be cloned together.
Wireless Clone Mode
(1) Turn on the source radio while holding down [PF5] simultaneously, the radio enters Clone Mode
with “CLONE” on the LCD, or enters User Mode if Clone Mode is set OFF by your dealer.
(2) Press [PF1], the radio enters Wireless Clone Mode with “WIRELESS” on the LCD. The initial
frequency that matches the destination is displayed in 2 seconds. Turn the Selector Knob to
choose desired frequency. Press [PF1] again to return to Clone Mode.
(3) Press [PF2] to toggle between Dealer Clone and Factory Clone Mode. “Dealer Clone” or “Factory
Clone” appears on the display when the corresponding mode is selected. The radio returns to
original display mode in 5 seconds.
Unlike Factory Clone Mode, adjustment settings and embedded messages are not covered in
Dealer Clone Mode.
Dealer Clone Mode is the default mode.
(4) Repeat step1-2 to operate the target radio, the frequency is set the same as that of source radio.
(5) Press [PF6] to start wireless cloning. The LED of source radio glows red and that of target radio
glows green during cloning. “CLONE 00%” is displayed on both source and target radios. “BUSY”
mark also appears on the target radio. The leftmost 2 digits (00) on the LCD show the data
transfer rate and count upwards in increments of 1 as data transmission/reception proceeds.
(6) When data transmission is completed, “END” appears on the source radio and red LED goes out.
Press [PF1], the source radio displays the frequency, repeat the above steps to continue wireless
cloning. The target radio reset when all data is received.