Reliance electric MinPak Plus, Instruction Manual

Page: 18 / 55

17
SECTION 4
STARTĆUP AND ADJUSTMENT
4.0 General
- This Section provides startĆup and adĆ
justment procedures to be followed after the assembly
andinstallation of the controller is complete. All initial
operation checks andfinal adjustments to the controller
must be made in conformance to the procedures, warnĆ
ings andrecommendations listedhere.
DANGER
THE MINPAK PLUS CONTROLLER IS AT LINE
VOLTAGE WHEN AĆC LINE POWER IS CONĆ
NECTED TO THE POWER UNIT INSIDE THE
CONTROLLER. BEFORE WORKING ON, OR
TOUCHING ANY INTERNAL PARTS OF, THE
CONTROLLER, REMOVE INCOMING AĆC LINE
POWER AT THE MAIN DISCONNECT SWITCH.
PERSONAL INJURY MAY RESULT IF THIS
WARNING IS NOT FOLLOWED.
DANGER
DURING INITIAL STARTĆUP, THE CONTROLLER
AND ITS ASSOCIATED EQUIPMENT MUST BE
OPERATED AND/OR ADJUSTED ONLY BY
QUALIFIED ELECTRICAL MAINTENANCE PERĆ
SONNEL. THESE INDIVIDUALS SHOULD BE
FAMILIAR WITH THE DESIGN AND OPERATION
OF THIS EQUIPMENT AND WITH THE HAZARDS
INVOLVED. PERSONAL INJURY AND/OR DAMĆ
AGE TO THE CONTROLLER COULD RESULT
FROM UNFAMILIARITY.
4.1 Power Off Inspection
- It is necessary to
make a superficial inspection of the MinPak Plus conĆ
troller andits associatedunits. The purpose of this
check is to look for possible physical damage or imĆ
proper connections.
Inspect all plugĆin Modification Kits. Test each for a firm
mounting condition.
Each shouldbe mechanically connectedto the RegulaĆ
tor Module by means of a mounting post screw. Each
shouldbe electrically connectedto the Module by a seĆ
ries of parallel pins. If any of the pins are bent, improper
operation results. Examine the pins to make sure they
are perfectly parallel. Only one pin may fit through a hole
in the Kit.
Inspect all screw terminal connections on the ModificaĆ
tion Kits. Make sure the wires are firmly connected. Also
make sure that there is enough insulation on the wires
to prevent a short between the conductors.
Inspect the signal wiring from the Operator Control StaĆ
tion. If a Local Station is usedon the Cover, there are 2
connectors that mate with the Regulator Module at Pins
32 (RED) and28 (GRN). (See Figure 4.2.)
If a Remote Station is used, a series of wires will connect
to individual terminals on a strip mounted on the ReĆ
mote Operator Interface Module. (This Module is
mountedon the Regulator Module. Refer to Figure 4.1.)
Determine that all wires are firmly seatedin the terminal
strip.
TEST
AREA
REFERENCE
AREA
REMOTE OPERATOR
ADAPTER MODULE
&
SWITCH
RECEIVER
MODULE
AREA
Figure 4.1 - Regulator Module Kit Locations