STEAM CLEANING
NOTE:
When replacing any accessories, make sure the machine is powered
off and no steam is ejected. The machine needs to cool for 15 minutes to
prevent risk of burn.
IMPORTANT: Do not use the
mop attachment
without a micr
ofi
ber pad
attached to the floor head.
NOTE: Do not use the carpet glide when cleaning hard floors.
1.
After confirming that the power supply is correct, plug in the power supply,
the power indicator light is on, and the machine will begin to heat up.
2.
After about 25 seconds, the machine is ready for use
.
Press the steam switch
and the steam will be ejected immediately.
3.
According to different cleaning requirements, you can adjust the steam with
the "+" and "-" buttons on the control panel until you reach the desired steam
amount.
NOTE: Do not aim steam at people, pets, plants or any other electrical
appliances during use to avoid burns or damage to the machine.
4.
Please pay attention to the amount of water in the tank when you use it. When
there is no water in the tank or the water is too low to allow the pump to
absorb water, please refer to the page on how to fill the machine.
NOTE: Do not operate the machine at any time without water in the tank.
1
0
