This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your Rejuvenation ceiling fan.
Unpacking Instructions
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
.
d
e
t
p
u
r
r
e
t
n
i
e
b
u
o
y
d
l
u
o
h
s
e
c
a
l
p
r
u
o
y
g
n
i
d
n
i
f
n
i
l
u
f
p
l
e
h
e
b
ll
i
w
d
n
a
d
e
t
e
l
p
m
o
c
n
e
e
b
e
v
a
h
s
p
e
t
s
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact Rejuvenation technical support at 888.567.2055
Tools Needed for Assembly
Materials
Wire Size A.W.G.
Installed Wire Length
14
12
Up to 50 ft.
50 - 100 ft.
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
4
1.
Check to see that you have received the following
parts:
Hardware Bags
Motor Assembly
Downrod/Hanger Ball
Assembly
Ceiling Canopy
• One Phillips head screwdriver
• One
1/4
˝
flat head screwdriver
• One stepladder
• One wire stripper
• One
hex wrench
• Four wire connectors
WARNING
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 11). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
• Motor Assembly
• Hanger Bracket Assembly
• Downrod/Hanger Ball
Assembly
• Ceiling Canopy
• Motor Coupling Cover Assembly
• Blade Holder Set
• Blade Holder Cover Set
• Light Plate Assembly
• Light Housing Assembly with Glass
• LED Assembly
• Hand-Held Remote
• Receiver Unit
• Canopy Trim Ring Assembly
• Hardware bags:
– Ten 1/4
˝
-20 Pan Head screws
(blade holder to fan motor hub)
with lockwashers
– Four wire connectors
Hanger Bracket
Assembly
Motor Coupling
Cover Assembly
Canopy Trim
Ring Assembly
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
Rejuvenation at 888.567.2055 for missing or damaged
parts.
Blade Holder Set
Blade Holder Cover Set
Light Plate Assembly
Light Housing Assembly
With Glass
LED Assembly
– Ten 3/16
˝
-24
Flat and Serrated
Head screw (blade to blade holder)
– Bag Assembly Safety Cable
Hand-Held Remote
Receiver Unit
