Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-13
www.rejuvenation.com
7/15
ATTACH THE VANITY BASE TO THE WALL (CONT’D)
6. Transfer the pilot hole locations to the back of the vanity base and drill 3/8” diameter
fastener clearance holes.
7.
With a helper, secure the vanity base to the studs or blocking using the fasteners
and washers supplied (see page 8 for cross-section view).
8.
If necessary, place shims between the vanity and wall so the vanity base is not distorted
and stays level in all directions.
9.
Push down on the vanity to check all 4 fasteners are holding properly.
