8
9.
Adjust the speed depending on saw blade (10):
Carbide saw blade:
Cutting width: 0,3 mm
Adjustment: 0 = approx. 1.500 t./min.
Cutting:
2 - 4 hours after finishing model or
up to 4 – 8 hours after storage in a hydrobox.
Diamond cutting blade „B“:
Cutting width: 0,36 mm
Adjustment: 5 = approx. 6.000 t./min.
Cutting:
8 hours after finishing the model at earliest
Diamond cutting blade „SD“:
Cutting width: 0,20 mm
Adjustment: 7 = approx. 9.000 t./min.
Cutting:
8 hours after finishing the model at earliest
10.
The motor starts by pressing simultaneously the pushbutton at the handle (1) and
at the model tray table (15) or alternatively by simultaneously pressing the
pushbutton at the housing (15) and at the model-tray® model table (15).
11.
Sawing is performed by moving forward the model table guidance (28) slowly from
the front into the model. Please avoid swinging of the saw blade. If necessary,
adjust position by removing magnet and table adjustment.
By using the standard table’s function (see chapter 4.2) the MODEL TRAY ® table may also
be used for sawing from top to bottom. Please pay attention to the correct depth-stop (19) and
release the locking screw (25). In case of dust formation additionally remove the suction
adaptor (29).
Attention:
During positioning please pay attention that the saw cuts don’t cross. Regarding
diagonal cuts always do a parallel cut as well so that the diagonally cut stump
segments may later be removed from the model-tray®-Sockler.
