9
Installation and removal of cleaning brushes
Cleaning brush removal:
Pull the mains power plug.
Pour out cleaning liquid down the sink.
Remove cleaning brush (6) by turning screw marked „L“ (4) to the left. Remover cleaning
brush (7) by turning
screw marked “R” (5) to the right.
Replace the cleaning brushes.
Fasten the screw marked „L“ (4) to the threaded insert
marked “L” by turning it to the right, in order attach the cleaning brush including a bristle-
less area.
Fasten the screw marked “R” (5) to the threaded insert marked „R“ by turning it
to the left, in order to attach the cleaning brush with extended bristles.
Fill the cleaning fluid (see chapter 4.1) into the tank.
Note:
Clean and protect your device regularly with the REITEL stainless steel care spray
(order-no.: 90405000) to remove lime, plaster and dust as well as other contaminants
from the surface of equipment and to prevent corrosion. The spray creates a water
repellent protective film which helps keep the equipment clean.
Note:
Use appropriate cleaning fluid in compliance with instruments manufacturers‘ instructions.
The cleaning brushes stop spinning on accidental manual intervention or as soon as
instruments get stuck in the appliance.
Summary of Contents for ROTOCLEAN EASY
Page 15: ...15 EC Conformity Declaration ...
