9
jetStamp
990
Important Notes
Before commissioning of the
jetStamp
990, always read the operating instructions and
in particular the safety notes with care. This prevents mistakes in handling of the marking
device and connected safety risks to keep you safe and avoid damage to the device.
Detailed operating instructions and further information can be found in the online help
of the PCset software or on the enclosed USB stick.
1. Preparation and Taking into Operation
1.1. Commissioning
The rechargeable batteries must be charged completely before the first use.
The charging time is approx. 3 hours. The rechargeable batteries are charged when the
green charge display
13
goes out.
Only connect the device to the PC after the PCset software has been installed, otherwise
the installation of the device drivers will fail!
Inserting rechargeable batteries
Always replace all rechargeable batteries at once. Date, time and counter reading of the
numbering machine are retained when the rechargeable batteries are removed.
f
Open the battery compartment flap
10
at the rear of the marking device.
f
Ensure correct polarity and insert the batteries.
f
Close the battery compartment flap
10
.
Charge the rechargeable batteries
f
Connect the mains adapter of the device to the connection socket provided for the mains
adapter
12
and connect it to the mains, or connect the device to a running PC by micro
USB
14
. Green charging indicator
13
lights up. Charging is complete when the charging
indicator
13
is off.
Inserting printing cartridge
When using special ink (MP), observe the notes in the operating instructions on the
print cartridge.
f
Take the
jetStamp
990 from the basis station
4
.
f
Push [MENU]
„Cartridge change Start“ appears on the display.
f
Push
[SELECT]
Print carriage moves to the device centre.
„Cartridge change End“ appears on the display.
