2. Preparation
The cover can be mounted without special tools.
It is much easier to mount the cover with two people.
The car (especially the roof) area should be as clean as possible before you mount the cover.
Please unfold the cover before mounting on a clean and dry surface with the silver side on the ground in order to find
the correct adjustment.
The higher side of the cover should be aligned to the elevating side of the roof, the windows to the side.
3. Pull the cover over the car
The elevating roof and the tailgate of the car should be closed before you pull the cover from the backside over the roof
of the car.
A second person would be helpful to pull the front corners (at the belt) parallel over the roof. Then the front corners
should be placed at the top of the front shield and the rear corners at the back of the roof.
Before you open the elevating roof you should fix the belts at the door seal, so that they have a direction when you raise
the roof. To avoid damage, please note that the adjustments and the hooks of the belts are placed at the end of the
belts.
4. Raising of the roof
Now you can raise the roof as usual.
The second person prevents that the cover slides down at the side of the roof.
5. Drag down the corner of the cover
Drag down the corners of the cover gently on the belts until the position of the cover is correct.
If it is not pre-installed, then pull the pads over the belt and fix the plastic adjusting and hooks with the four ends of the
belts.
6. Fix the belts to the car
The belts will be fixed on the front to the wheel housing and on the back to the bumper.