Rehau AWADUKT PP, Assembly Instructions Manual

Page: 16 / 20

EN
8. Attach the clamp nut and tighten hand-tight
with provided socket wrench SW13 without
additional lever extension. Check the position
of the clamping rope again.
9. Carry out the welding process
Connect the welding cable to the electrofusion
saddle in a load relieved way, enter the welding
data, e.g. using a barcode reader, check the
display on the welding machine and carry out the
welding process.
The welding machine manufacturer‘s specifica-
tions are to be observed.
Only electrofusion welding machines
are to be used that fulfil the require-
ments of the DVS Guideline DVS 2208-1
(outside of Germany - see equivalent national
guideline).
For safety reasons, maintain a distance of
at least 1 metre away from the welding area
during welding.
The welding point must not be moved
anymore or loaded with external forces during
the entire welding process until it has cooled
completely (see cooling time). The clamping
rope must only be removed once the cooling
time has elapsed.
10. Optional step
Attach the holding rope with a fixing screw
(an optional step to prevent the milled out
section falling into the main pipe).
11. Attach Component 1 to the collar of the drill
machine using a 6 mm external hexagon
socket wrench.
Component 1
16