31
6.
Insert the compression sleeve all the way up to the fitting collar by
activating the pressure switch / foot lever.
5. Insert joint fully into clamp ing tool.
Caution:
Do not tilt. Tool must be applied over full surface and at right angles.
Processing at temperatures of under -10°C and over 45°C may result
in damage to the joint components, the tool and/or in personal injury
- Do not work below the minimum processing temperature of -10°C
- At low temperatures (below 0°C), it is recommended that the
joint components be stored in a warm environment before
processing
Please observe also the instruction leaflet of the compression
sleeves 110x10!