1. Proper use:
The toilet seat height adjuster enables persons with limited mobility (e.g. with knee and hit joint
problems or geriatric complaints), to use the toilet without assistance, to sit down and stand up
comfortably. It is suitable for permanent installation.
2. Warning
:
Unpack the product and check it for completeness and damages. If you should detect damages or if
parts are missing, contact your dealer. Read the operating instructions carefully prior to using the toilet
seat height adjuster and store where it will be available for later use. If you should happened to lose it,
request a replacement copy from the dealer.
3. Assembly instructions for the toilet seat height adjuster
The seat height can be adjusted to three levels (8 cm, 10 cm and 13 cm).
Make sure that the height adjustment rods are securely locked in place/screwed tight. Prior to
assembly set the desired seat height by turning the lower of the two height adjusters on the
bottom.
On the rear component you will find two threaded rods under the height adjuster. Set the space
between these rods so that they fit into the holes in the toilet bowl. Insert the rods through the holes
from above and show one quick-lock each over the rods down onto the ceramic. Tighten the quick-
locks finger tight.
The SOLIDCLIP mounting system simplifies the assembly
onto the toilet bowl.
Press the moveable interior component of the SOLIDCLIP
forward and take hold of it on the back. Press it together
lightly.
Now shove the SOLIDCLIP on the threaded rod until it hits
against the toilet’s ceramic surface.
“Toilet Seat Height Adjuster“ RFM with 3 height settings
EN
