Regulus HR 100 W, User'S Installation And Operation Manual

Page: 8 / 12

- 8 -
5. Maintenance
5.1 Cleaning
1.
In addition to removing odours, providing fresh
air and recovering heat, this unit extracts airborne
impurities such as dust, dirt and grease. These
gradually build up and detract from the ef
fi ciency
and appearance of the unit.
2.
To ensure optimum performance, the unit
should be cleaned every 3 to 6 months or at
periods determined by the level of contamination
experienced.
3.
Isolate the mains power supply.
4.
Undo the two grille securing screws and remove
the grille (Fig. 12).
5.
Pull out the four cylindrical inserts from behind
the grille and remove the fi lter (Fig. 13).
6.
Slide out the heat exchanger (Fig. 14).
7.
Wash the grille, fi lter and heat exchanger in warm
water using a mild detergent and dry thoroughly.
CAUTION: Keep water away from all electrical
components and wiring within the unit.
If the fi lter cannot be cleaned, a replacement
is necessary.
8.
Reassemble in reverse order ensuring the fi lter
and heat exchanger are seated correctly. The heat
exchanger shall be positioned with the TOP mark
pinpointing to the front and upwards.
9.
Switch power supply on and check the operation
of the unit.
HR30W
HR30W is fi tted with an extra fi ne pollen fi lter (Art.
No. FR30RF4). Its maintenance is the same as that
of the standard
fi lter, see Cleaning (section 5.1).
grille grille
screws screws
heat exchanger heat exchanger
spacers spacers
fi lter fi lter
grille grille
Fig. 13 Fig. 13
Fig. 12 Fig. 12
Fig. 14 Fig. 14