Regency Plateau™ PTO30 Outdoor Gas Fireplace
11
INSTALLATION
2
PTO30
919-127
06/06/12
11)
Attach the label “This unit has been converted to LPG/ULPG” near or on
top of the serial # decal.
12)
Replace yellow “NG” label with red “LPG/ULPG” label.
Make appropriate gas connections.
10)
Remove Hi/Lo pressure regulator by removing 2 screws as shown below.
Reverse steps to install LP pressure regulator. (Be sure diaphragm and
spring are removed.)
HI/LO pressure
regulator
13)
Check all gas connections under normal operating pressure, for leaks,
with soapy water.
NOTE:
If soap bubbles, this would indicate a gas leak.
14)
Check inlet and outlet pressures.
15)
Check operation of fl ame control.
9)
Remove 6 screws on valve access cover.
