30
L390E-1 / HZI390E-1 Direct Vent Gas Insert
INSTALLATION
L390E LOG SET INSTALLATION
1)
Identify Log 1 pins on left side of log burner in unit - see below.
3)
Position Log 1 on burner pins as far forward on the back pin as pos-
sible and as far to the left as the left pin allows.
4)
Position Log 2 on burner pins located in the right rear corner. When
seated, Log 2 should sit fl at and not rock.
2)
Identify corresponding locators on bottom of Log 1 - see below.
Log 1 pins on burner tray
Log 1 locators
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*Satin black paint is included if touch ups are required.
1
Rear Bottom Left Log
2
Right Upright Log
3
Front Log Piece
4
Front Angled Log Piece
5 Back
Top
Log
6
Front Left Cross Log
1
2
3
4
6
5
