24
Regency
®
HZI234E Direct Vent Gas Insert
INSTALLATION
LOW PROFILE FACEPLATE INSTALLATION
(3 AND 4 SIDED)
1)
Install 4 screws on sides of unit - in locations show below - do not tighten
screws.
2)
Install the faceplate backing plate - slide the keyhole slots on the
faceplate over the screws installed in Step 1. When in position, tighten
screws.
3)
From the right side of the unit, remove the on/off switch box cover, one
screw top and bottom. Connect the red female ON/OFF valve connec-
tors to the ON/OFF switch located on the right faceplate panel.
4)
Remove the battery pack holder from the right hand side faceplate.
5)
Peel off the tape from the velcro strips and Install batteries into the
Battery Pack Holder (batteries are included with packaged manual.
6)
Place battery pack onto Velcro strips from right faceplate panel.
